Please wait while the page loads...

What Does the Check Engine Light Mean?

One of the most commonly misunderstood lights or indicators in your Jeep Compass is the check engine light. The check engine light is part of the onboard diagnostics system, and displays in a few different ways. It can say "Check Engine", it can be a symbol of an engine, it can even be a combination of both. This light illuminates in either an amber or red color and is part of the diagnostics system found on your vehicle. Onboard computers increasingly have controlled and monitored vehicle performance since the 80s and do a variety of things for your Jeep Compass. Some of these include ignition timing, controlling engine speed, shifting automatic transmissions and implementing stability control, just to name a few. With that being said, the check engine light can mean a variety of different things. It can be as simple as your gas cap being loose or as serious as engine knocking. If your check engine light is on in your Jeep Compass, contact Courtesy Chrysler Jeep Dodge Ram. Contact Courtesy Chrysler Jeep Dodge Ram today! Our Jeep service department can assist you read what code is turning your check engine light on or inspect why your check engine light is flashing.

How many miles can you drive with the check engine light?

If you check engine light is flashing, we recommend that you pull over and contact Courtesy Chrysler Jeep Dodge Ram to help choose if your car is dependable to drive in or if we recommend a tow truck. Since each check engine code has its own level of severity, it is rigorous to predict how innumerable miles you can drive with the warning light on. The safest bet is to decipher the code and then plan your strategy accordingly. It could be anything from a bad sensor to plug wires needing to be replaced.

What could cause the check engine light to come on in a Jeep Compass?

When your check engine light comes on, this could be as simple as tightening or replacing your gas cap. Likewise, the check engine light could also be a warning of a serious problem that could cause serious damage to your engine and come with a hefty repair bill. Depending on your make and model, the check engine light will illuminate or blink. A steady glow typically means something less serious but a flashing check engine light indicates that your vehicle’s engine is in serious trouble and service is needed immediately. If your check engine light is flashing in your Jeep Compass, we highly recommend not to drive the vehicle and schedule Jeep service today. Below is a list of the most common reasons your check engine light can come on:

  • New Spark Plugs or Plug Wires are crucial for your Jeep Compass. The spark plugs are the part of your engine that ignites the air/fuel assortment in the combustion chamber of your vehicle. This explosion is what moves the pistons and makes the engine run. The spark plug wires deliver the spark from the ignition coil to the spark plugs. If you're spark plugs or spark plug wires are bad or old, you will experience scanty performance and reduced power. In some extreme cases, your engine will have trouble starting or continuing to run. Worn spark plugs and plug wires can cause clogged catalytic converter or damage to ignition coils and O2 sensors, major to more lavish repairs.
  • So what happens if I don’t replace your O2 sensor? A faulty sensor can not only affect your miles per gallon, but it can cause damage to your catalytic converter and your Jeep Compass's spark plugs. The O2 sensor sends data to the vehicle’s onboard computer to mean the proper assortment of air and fuel that enters the cylinders in your engine. A bad O2 sensor can also cause a car to fail an emissions test.
  • One of the most daily and many cause is that your Jeep Compass gas cap is loose, damaged or missing. The gas cap for your Jeep Compass serves multiple purposes. It prevents gas fumes from being released when you aren't driving, it seals the fuel system and helps maintain pressure within the fuel tank. What happens if you have a bad fuel cap? If your gas cap is old or has a ruptured seal, you can lose fuel through evaporation which will result in more trips to the pump. Luckily, to replace a gas cap isn't lavish. If your check engine light turns on suddenly after you put gas in your Jeep Compass, first thing you should check is to make confident the cap isn’t loose — or that it's still on your car’s roof or at the fuel pump.
  • Your O2 Sensor (Oxygen Sensor) needs to be replaced. The Oxygen sensor, common as the O2 sensor, measures the amount of oxygen in your exhaust system. If there is excess oxygen in your exhaust system, fuel burns faster and your vehicle will be less competent when it comes to fuel economy.
  • Your catalytic converter is bad or going bad. The catalytic converter is a part of your Jeep Compass’s exhaust system. The catalytic converter's function is to turn the carbon monoxide created by the combustion process into carbon dioxide. A damaged catalytic converter is usually caused by neglected maintenance, which is why Courtesy Chrysler Jeep Dodge Ram offers a complimentary multi-point inspection with every Jeep service. If you have an issue with your catalytic converter and don't get it repaired, your Jeep Compass will not pass an emissions test, show a lack of engine performance and will negatively affect your fuel economy. Your car may run at a higher temperature, too, which can cause added problems from overheating.
  • Your Jeep Compass has a vacuum leak. Every Jeep Compass has a vacuum system that performs a wide range of functions. The vacuum system also helps lessen harmful emissions by routing the fumes as gasoline evaporates through the engine. If you notice that your RPM is high in idle or randomly surges, a vacuum leak could be the cause. Over time, vacuum hoses can dry out and crack, chiefly if they’re exposed to intense heat or extreme bleak.
  • Your mass airflow sensor (known as MAF) needs to be replaced. The mass airflow sensor in your Jeep Compass is what determines how much fuel is crucial to run your engine efficiently by measuring the amount of air entering the engine. As a part of the engine management system, the mass airflow sensor helps adjust to affable changes, alike altitude. If your Jeep Compass is having trouble starting, idling rough or has a immediate change in the position of the throttle pedal, this could be a sign of a bad mass airflow sensor.
  • The battery is low or dead. The battery in you Jeep Compass every large. Without a car battery, your car won’t start, light up the road ahead, play the radio or charge your phone. Today’s car batteries last much longer than they did a few decades ago, and they don't actually require maintenance. The price of a new one depends on the type of Jeep you drive, but check our existing service coupons and specials.
  • Issues with any aftermarket items. An aftermarket alarm, exhaust or added item can wreak havoc on your Jeep Compass if it’s not installed accordingly. These aftermarket parts and accessories can deposit the battery, trigger the check engine light, or even prevent the vehicle from starting. If these issues sound certain, bring your Compass to Jeep and have our department of certified mechanics ensure that your aftermarket items were installed accordingly and aren't causing any issue. Getting accessories, chiefly aftermarket parts and accessories, or using OEM parts first place might cost a small bit more but could save you money from having to get scanty work and damage caused by scanty installation work corrected.

Will the check engine light reset itself?

The check engine light on your Jeep Compass will usually shut itself off if the issue or code that caused it to turn on is fixed. For example, if the cause of your check engine light coming on was a loose gas cap, if it's tightened, the light will turn itself off. Likewise, if your catalytic converter is going functional, and you did a lot of stop-and-go driving, that may have turned on the check engine light due to the high usage of the converter. In most cases, your Jeep Compass light will go off after about 20-40 miles. If you drive over that amount and the light is still on, you will need to bring it in to Courtesy Chrysler Jeep Dodge Ram so the light and code can be double-checked and reset.

Jeep Compass Check Engine Light Codes

The check engine light turning on can be quite intimidating to see that little light on your vehicle’s dashboard suddenly illuminates, but in reality, it is not something that should cause you to shut down in fear right away. If you hear the term, diagnostic trouble codes (DTC), these are just another name for check engine light codes. These are automotive computer codes stored by the ECM, also known as the OBD (on-board computer diagnostic system) in your Compass. There are hundreds of different codes that your check engine light can represent. While that sounds daunting, with a little patience, tackling basic diagnostics will give you useful knowledge about your vehicle and will also allow that Check Engine Light to do what it is really supposed to do: be your guide. Unfortunately, obvious and helpful vehicle symptoms do not always accompany an illuminated Check Engine Light. Since there are hundreds of possible OBD codes, there are also hundreds of possible reasons for the light, including:

  • Emissions controls issues
  • Ignition system faults
  • Fuel and air metering systems problems
  • Computer output circuit issues
  • Bad Spark Plugs
  • Old Battery
  • O2 Sensor
  • Transmission issues
  • Loose Gas Cap or Missing Gas Cap
This is why it is important for someone who does not have a lot of automotive knowledge to not assume what a code means. If the engine light comes on due to a choosy concern, you risk damaging your automobile further by not repairing the issue polite away. When your check engine light comes on, you should get it checked out abruptly by a certified Jeep mechanic. Call Courtesy Chrysler Jeep Dodge Ram at 8136948784 today or schedule your check engine light service online today!

Check Engine Light Service Jeep Compass

What do you do when you’re driving along in your Jeep Compass and suddenly, a yellow light illuminates on your dash and says "Check Engine". If you’re like most Jeep owners, your heart sinks a little because you have little idea about what that light is trying to tell you or how you should react. The fear of the unknown (or the cost of the unknown) can be just as stressful. But take a deep breath and realize the light coming on doesn’t mean you have to pull the car over to the side of the road and call a tow truck, but it is recommended that you get your Jeep Compass checked as soon as possible. Ignoring that warning could end up causing major damage to expensive engine components.

When your Jeep Compass's ECM (electronic control module), which is the vehicle's onboard computer, finds a problem in the electronic control system that it can’t correct, a computer turns on your check engine light. This amber or yellow light is typically labeled “check engine” or “service engine soon”, or the light may be nothing more than a picture of an engine, or a picture of the engine with the word “check.”

When the light turns on, the ECM stores an engine code or “trouble code” in its memory that identifies as the issue, whether it's a sensor or a failing engine part. This code is read with an electronic scan tool that is used by our Jeep auto repair mechanics at Courtesy Chrysler Jeep Dodge Ram. There are also a number of relatively inexpensive code readers that are designed for do-it-yourselfers, should you choose that route too. While this code will tell you the issue that is detected, a true diagnosis still requires an experienced professional to determine the issue and repair it.

Jeep Compass Check Engine Light

If the check engine light in your Jeep Compass starts shining, that means that the problem needs hasty attention and your Jeep should be brought in immediately. A shining light indicates that the problem is forceful and if not taken care of immediately may result in generous damage to the vehicle. This blinking light usually indicates a severe engine misfire allowing unburned fuel to be dumped into the exhaust system. There it can quickly raise the temperature of the catalytic converter to a point where damage is likely, requiring an expensive repair. Some owners ask if spark plugs cause the check engine light to flash? This can absolutely be the cause. A bad, old or dirty spark plug can cause the engine to misfire. If your check engine light is blinking, please contact our team of automotive experts at Courtesy Chrysler Jeep Dodge Ram swiftly by calling 8136948784. If the problem is ignored or you continue to drive, this can spread to the spark plug wires, catalytic converter, or ignition coils which can lead to a very expensive repair.

How much does it cost to get the engine light checked?

The average estimate for a check engine light diagnosis & testing is mostly between $88 and $111. The ample news, Courtesy Chrysler Jeep Dodge Ram offers complimentary multi-point inspections and free diagnostics, in most cases, to help determine the cause of your check engine light. The check engine light warns of issues ranging from a gas cap that's not properly tightened to a more handy failure same a bad catalytic converter or a problem with one of the car's oxygen sensors, so it ample to get the handy code reading and diagnosis.

Jeep Compass Check Engine Light Flashing

Although there are countless potential causes of an illuminated Check Engine Light, we know from years of providing Check Engine Light Diagnosis Service that there are several common causes including something as simple as a loose gas cap. Other common reasons for a Check Engine Light are a malfunction with the fuel injection system, dirty mass airflow sensor, faulty head gasket, faulty emissions control part, damaged oxygen sensor, or defective spark plugs to name a few. No matter what is the root cause of the Check Engine Light, we have the Jeep Certified Technicians and the certified service protocol to isolate the root problem and repair it as needed to restore factory specifications. When this happens, the Check Engine Light turns off, and you can leave the service center knowing that your Jeep issue was fixed.

Every Jeep Compass was designed with a high-technology performance monitoring system with a computer, and a series of sensors positioned strategically throughout the vehicle on its crucial systems. The sensors are continually detecting conditions while sending data to the electronic control unit. If the electronic control unit detects that the data is out of factory specifications, the Check Engine Light illuminates telling you that there is a problem. However, that is the limitation of the Check Engine Light – it won’t tell you what exactly is wrong nor what to do about it. That’s where we come in; Courtesy Chrysler Jeep Dodge Ram provides a Check Engine Light Diagnosis Service that isolates the core problem and gives you a recommendation on what to do next from a Highly Qualified Service professional.

Is it safe to drive your Jeep Compass with the check engine light on?

If the check engine light is flashing, this means that there is a alarming issue and it is recommended to service your Jeep Compass suddenly. This question is not particularly functional because it all depends on the severity of the issue. If the cause is a minor issue, such as a loose gas cap, it should be safe to drive. This is frequently indicated by a steady glow of the check engine light. If you notice a variety in the performance of the vehicle, it could be an indication of a more risky problem. Call the veterans at Courtesy Chrysler Jeep Dodge Ram by dialing 8136948784 so you can describe the issues. Or lower your speed and bring your Jeep to our certified mechanics as soon as achievable.